|Tax Status:||Tax Paid|
Mountshannon Co Clare Ireland
Jabiru is a fin keel 1990 Westerly Fulmar.
She is well maintained and fully equipped, including Furuno radar, for offshore coastal cruising.
Engine type is a Volvo 2002h.p .(major overhaul 2016)
Her sails are in good condition and includes a spinnaker and cruising chute.
She is fitted with a rope cutter and Kiwi folding prop. Original 2 bladed prop also included.
Jabiru is for sale with her 6 support cradle, a Yam 250T inflatable dinghy and a 4 stroke 2.5h.p. Suzuki outboard.
A complete inventory of equipment is attached.
Jabiru is on the hard stand until the end of March 2019
|Vessel type:||Sailing Yacht|
|No. of engines:||1|
|Engine model:||Volvo Penta|
|Drive type:||Shaft drive|
|Length over all:||31' 10"|
|Length at waterline:||26'|
|Maximum draft:||5' 3"|
|Hull material:||Glass Fibre|
|Keel type:||Fin Keel|
|Fuel capacity:||20 Gallons|
|Water capacity:||30 Gallons|
Volvo Penta 2002 18HP
Major overhaul 2016
Fresh Water cooled
Shaft Drive to 3 Bladed Kiwi Prop
Original 2 Bladed Prop also included
Pressurised hot and cold water system
Heated by engine calorifier and immersion heater
The main Hull and Deck is manufactured using Glass Reinforced Plastic (GRP). GRP matting and a polyester resin are laminated in moulds to produce the Hull and Deck shapes. The outer surfaces have a gelcoat layer approximately 1mm thick which provide a water resistant skin.
Three types of GRP are used : Unidirectional mat for high strength and reinforcing, woven roving for high strength and reinforcing, chopped strand Mat (CSM) for intricate mouldings.
PVC foam is used in deck and coach roof mouldings for strength. It is light in weight and does nor absorb water.
Plywood is used in high load areas such as stanchion basis. Aluminium plate is used at the mast heal plinth for high strength.
Hull stiffening is achieved using bulk heads and stringers. The stringers are polyurethane foam formers overlaid with GRP, on the inside of the hull and underside of the deck.
Sleeps 6 in 2 Cabins and Quarter berth
Forward Cabin with Double V-Berth
1 Single berth and 1 Double berth in saloon
1 Quarter berth to port
Galley area with Plastimo Neptune 2000 gas 2 rings, oven/grill
Sink and coolbox
Heads compartment with Jabsco w.c. and handbasin
Cabin heating (Espace)
Teak interior joinery
Two 12V batteries
Switched and charged by engine alternator
Shore power and cable
Stainless steel fuel and water tanks
Rocna anchor, 15kg with 30m of 7mm chainand warp
Bruce kedge anchor, 15kg with chain and warp
Simpson Lawrence Sprint 500 electric windlass, Reconditioned (2013)
Manual bilge Pump
2 Winch handles
Guardwire, pulpit and pushpit
Sprayhood and dodgers
Warps, fenders and 2 boathooks
Cutlery, crockery and utensils
2 Diesel cans
1 Petrol can
Yam 250T Inflatable Dinghy (2004)
Suzuki - 4 Stroke 2.5HP outboard engine
A 6 support boat cradle
A large selection of Admiralty Charts
Aluminium mast, boom and spinnaker pole
Stainless steel standing rigging (2000), Backstay (2007)
Rotostay furlong headfoil (2013)
Terylene running rigging
Mainsail reefing with lazy jacks and stackpack (2013)
Main Sail - Crusader Sails (2010)
Genoa - Crusader Sails (2008)
Spinnaker - (2008)
Cruising Chute - (2000)
Two 2 - Speed genoa winches
Two 2 - Speed halyard winches
Raymarine ST60 Tri data, Depth speed and log (2003)
Raymarine ST60 wind (2003)
Raymarine ST60 Multi (2003)
Garmin 120 GPS (2014)
Furuno primary radar (2004)
Icom M421 VHF (2006)
XN2000 handheld VHF
Raytheon ST4000 autopilot (1998)
Navtex pro plus (2012)
Raymarine wind Vane (2011)
Liferaft (Serviced 2014)
Carbon Monoxide alarm