|Tax Status:||Tax Paid|
Galway Co Galway Ireland|
Classic Blue Water Cruiser, once in a lifetime opportunity to purchase this much sought after 45 foot cutter.
“MARANIAFE” is a Cape George Cutter 45 – design inspired by William Atkins, moulded by Cecil Lange at Cape George Marine Works, 1924 Cape George, Port Townsend, Washington 93368, United States.
She was was home completed over five years.
Commissioned in 2005.
|Vessel type:||Cutter Sailing Yacht.|
|Builder:||Cecil Lange, Cape George Marine Works|
|Fit Out:||Cedar, Sapele and Douglas Fir and Teak|
|No. of engines:||1|
|Engine model:||Perkins LD33472|
|Drive type:||Shaft drive|
|Length over all:||44'|
|Length at waterline:||36'|
|Hull material:||Glass Fibre|
|Keel type:||Full Keel|
|Fuel capacity:||70 Gallons|
|Water capacity:||120 Gallons|
|Holding tank capacity:||88 Gallons|
Peak compartment for storage anchor chain access onto the fore deck. Collision bulkhead.
Main cabin with double berth and storage.
Saloon with large table and seating air con beneath saloon seating.
Aft galley to starboard with nav station to port.
Shower cubicle with wet locker aft of galley to starboard with head compartment to port.
Pilot berth aft to starboard.
Large cockpit with good locker storage.
Single skin of hand laid roving using vinylester resin.
Deck beams and Carlins are in laminated Port Oxford Cedar.
Decks and superstructure in marine grade ply to BS1088 all heavily sheathed in FRP mat and roving.
Raymarine plotter with overlay
Raymarine wind, depth, speed autohelm.
Fisher Panda gen set
Single Perkins LD33472 60kW marine diesel engine.
Engine last run in 2017. Requires servicing and flushing out of old fuel. Good access to unit. Drives shaft with feathering 3 blade prop.
Mast and boom in good order
Working jib serviceable
Mainsail some small repairs required
Origional standing rigging
Some running rigging replacement required.
Note: Indicated location is approximate general area only.